5
Chapter 1
1.6 Safety Precautions
FCC
This device complies with the requirements in part 15 of the FCC rules.
Operation is subject to the following conditions:
1.
This device may not cause harmful interference
2.
This device must accept any interference received, including inter-
ference that may cause undesired operation
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer-
ence when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
device in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his/her
own expense. The user is advised that any equipment changes or modifi-
cations not expressly approved by the party responsible for compliance
would void the compliance to FCC regulations and therefore, the user's
authority to operate the equipment.
Warning!
Always completely disconnect the power cord from
your chassis whenever you work with the hardware.
Do not make connections while the power is on. Sen-
sitive electronic components can be damaged by
sudden power surges. Only experienced electronics
personnel should open the PC chassis.
Caution!
Always ground yourself to remove any static charge
before touching the motherboard, backplane, or add-
on cards. Modern electronic devices are very sensi-
tive to static electric charges. As a safety precaution,
use a grounding wrist strap at all times. Place all
electronic components on a static-dissipative surface
or in a static-shielded bag when they are not in the
chassis.
Summary of Contents for IPC-644 Series
