3.3.2 Replacing the filter in front of the fan
1. Open the drive bay door.
2. Refer to Figure 3-2 and lift the filter holder with two fingers.
3. Remove the filter and replace it with a new one.
4. Slide back the filter holder and close the drive door.
Figure 3-2 Changing the filters
3.4 Replacing the power supply
IPC-7220 supports both 300W PS/2 and 300W redundant power supply.
To change the power supply, refer to Figure 3-3 and proceed as
follows:
1. Un-plug the AC inlet from the power supply of IPC-7220.
2. Remove the cover of IPC-7220.
3. Remove three screws, which mount the power supply bracket to
the chassis, then lift the power supply bracket.
19
4. Unplug the ATX power connector and +12V power connector
from the motherboard, the floppy drive power connector from
the floppy drive disk, and the peripheral power connector(s)
from the hard drive disk(s).
Summary of Contents for IPC-7220
