4
Flexible Input Type and Range Settings
The MIC-3716 features an automatic channel/gain scanning circuit.
This circuit design controls multiplexer switching during sampling.
Users can set different gain values for each channel according to their
needs for the corresponding range of input voltage. The gain value
settings thus selected is stored in the SRAM. This flexible design
enables multi-channel and high-speed sampling for high-performance
data acquisition.
On-board FIFO (First-In-First-Out) Memory
The MIC-3716 provides an onboard FIFO memory buffer that can
store 1K samples. Users can either enable or disable the interrupt
request feature of the FIFO buffer. While the interrupt request for
FIFO is enabled, users are allowed to specify whether an interrupt
request will be sent with each sampling action or only when the FIFO
buffer is half saturated. This useful feature enables a continuous
high-speed data transfer with a more predictable performance on
operating systems.
16 Digital Inputs and 16 Digital Outputs
The MIC-3716 provides 16 digital input channels and 16 digital
output channels. This leaves you with great flexibility to design and
customize your applications according to your specific needs.
On-board Programmable Counter
The MIC-3716 is equipped with a programmable counter, which can
Summary of Contents for MIC-3716
