69
Analog Output
Channels
2
Resolution
16-bit
Operation mode
Single output
Throughput
200 KS/s max. per channel ( FSR)
Using Internal
Reference
0 ~ +5V, 0 ~ +10V, - 5V ~ + 5V, - 10V ~
+10V
Output Range
( Internal &
External
Reference)
Using External
Reference
0 ~ +x V @ + x V ( - 10
≦
x
≦
10 )
- x~ +x V @ + x V ( - 10
≦
x
≦
10 )
DNLE: ± 1 LSB (monotonic)
INLE: ± 1 LSB
Zero (Offset) error: Adjustable to ± 1 LSB
Accuracy
DC
Gain (Full-scale) error: Adjustable to ± 1
LSB
Setting Time
5 µs ( to 4 LSB of FSR )
Dynamic
Performance
Slew Rate
20 V / µs
Drift
10 ppm /
°
C
Driving
Capability
±20mA
Output
Impedance
0.1
O
max.
Digital Input/Output
Input Channels
16
Low
0.4 V max.
Input Voltage
High
2.4V min.
Low
0.4 V max. @ - 0.2mA
Input Load
High
2.7V min. @ 20
µ
A
Output Channels
16
Low
0.4 V max. @ + 8.0 mA (sink)
Output Voltage
High
2.4V min. @ - 0.4 mA (source)
Counter/Timer
Channels
3 channels, 2 channels are permanently
configured as programmable pacers;1 channel
is free for user application
Resolution
16-bit
Compatibility
TTL level
Base Clock
Channel 2:Takes input from output of channel 1
Channel 1:1MHz
Channel 0: Internal 1MHz or external clock ( 10
MHz ) max Selected by software
Max. Input
Frequency
1 M Hz
Low
0.8 V max.
Clock Input
High
2.0 V min.
Low
0.8 V max.
Gate Input
High
2.0 V min.
Low
0.5 V max. @ +24mA
Counter Output
High
2.4 V min. @ -15mA
Summary of Contents for MIC-3716
