MIC-7900 User Manual
70
4.3
Install USB 3.0
4.3.1
Introduction
MIC-7900 provides 4x USB 3.0 and the data transfer rate of USB3.0 (5Gb/s) is 10
times to USB2.0 (480 Mbps). These 4 USB 3.0 port supports 5v standby power.
Insert the driver CD into your system’s CD-ROM drive. Navigate to the "03 USB3.0"
to install the drier.
4.4
LAN Configuration
4.4.1
Introduction
The MIC-7900 has dual Gigabit Ethernet LANs via dedicated PCI Express x1 lanes
(Intel® I210IT (LAN1) and I210IT (LAN2)) that offer bandwidth of up to 500 MB/sec,
eliminating the bottleneck of network data flow and incorporating Gigabit Ethernet at
1000 Mbps.
4.4.2
Features
10/100/1000Base-T Ethernet controller
10/100/1000Base-T triple-speed MAC
Full duplex at 10, 100, or 1000 Mbps and half duplex at 10 or 100 Mbps
Wake-on-LAN (WOL) support
PCIe x1 host interface
4.4.3
Installation
The integrated Intel® gigabit Ethernet controller supports all major network operating
systems. However, the installation procedure varies with different operating systems.
In the following sections, refer to the one that provides the driver setup procedure for
the operating system you are using.
Note!
Before installing the LAN drivers, make sure the CSI utility has been
installed on your system. See Chapter 4 for information on installing the
CSI utility.
Summary of Contents for MIC-7900
