MIT-W101 User Manual
12
3.1
Connecting the Power
Before you can use your MIT-W101, you must fully charge the battery. Connect the
power adapter as shown and leave it to charge for:
A minimum of 2 hours when using the internal battery
A minimum of 4 hours when a second battery is installed
Conditions: operating time is based on the LCD backlight at 50% and the average uti-
lization of the system under 10%.
Installation Procedures:
1.
Connect the female end of the power adapter to the DC-in of MIT-W101-A.
2.
Connect the female end of the power cord to the DC power adapter.
3.
Connect the 3-pin male plug of the power cord to an electrical outlet.
3.2
Connecting to a Monitor
You can connect the MIT-W101 to an external monitor for enhanced viewing.
Connect one end of a HDMI to VGA cable to the Micro HDMI port on the left side of
the MIT-W101.Connect the other end to the VGA cable and connect to the monitor.
Note!
Be sure always handle the power cords by holding the plug ends only.
Summary of Contents for MIT-W101
