PCM-9362 User Manual
32
3.3.7
APM Configuration
Figure 3.13 APM Configuration
Power Management/APM
Enable or disable APM.
Power Button Mode
Power on, off, or enter suspend mode when the power button is pressed. The follow-
ing options are also available.
Restore on AC power Loss
Use this to set up the system response after a power failure. The "Off" setting keeps
the system powered off after power failure, the “On” setting boots up the system after
failure, and the "Last State" returns the system to the status just before power failure.
Video Power Down Mode
Power down video in suspend or standby mode.
Hard Disk Power Down Mode
Power down Hard Disk in suspend or standby mode.
Standby Time Out
Go into standby in the specified time.
Suspend Time Out
Go into Suspend in the specified time.
Resume On Ring
Enable / Disable RI to generate a wake event.
Resume On PME#
Enable / Disable PME to generate a wake event.
Resume On RTC Alarm
Enable / Disable RTC to generate a wake event.
Summary of Contents for PCM-9362 Series
