PCM-9362 User Manual
38
3.4
Advanced PCI/PnP Settings
Select the PCI/PnP tab from the PCM-9362 setup screen to enter the Plug and Play
BIOS Setup screen. You can display a Plug and Play BIOS Setup option by highlight-
ing it using the <Arrow> keys. All Plug and Play BIOS Setup options are described in
this section. The Plug and Play BIOS Setup screen is shown below.
Figure 3.19 PCI/PNP Setup (top)
Clear NVRAM
Set this value to force the BIOS to clear the Non-Volatile Random Access Memory
(NVRAM).The Optimal and Fail-Safe default setting is No.
Plug & Play O/S
When set to No, BIOS configures all the device in the system. When set to Yes and if
you install a Plug and Play operating system, the operating system configures the
Plug and Play device not required for boot.
PCI Latency Timer
Value in units of PCI clocks for PCI device latency timer register.
Allocate IRQ to PCI VGA
When set to Yes will assigns IRQ to PCI VGA card if card requests IRQ. When set to
No will not assign IRQ to PCI VGA card even if card requests an IRQ.
Palette Snooping
This item is designed to solve problems caused by some non-standard VGA card.
PCI IDE BusMaster
When set to enabled BIOS uses PCI busmastering for reading/writing to IDE drives.
Summary of Contents for PCM-9362 Series
