11
TPC-100W Series User Manual
C
ha
pte
r 2
Sy
ste
m
S
etu
p
2.2
System configuration
TPC-100W is a compact touch panel with IIoT functions for industrial applications.
The system setup will be completed by the dealer or system integrator prior to deliv
-
ery. However, users may still need to access the system to adjust configuration, such
as the interface or boot modes. Before powering on, please open the rear bracket
and select the correct mode. Configuration can be set via the switch on the TPC-
100W rear board as shown below.
The default setting is RS232 mode and eMMC Boot. Kindly refer to the following pin
definition table for mode switch.
Boot Mode: option (SW2)
SD boot (Install image)
1. OFF
2. ON
3. ON
eMMC boot default
1. ON
2. OFF
3. OFF
Warning!
To avoid the system damage, the device may unable to incorrect or
undefined switch may cause the system may be damaged when the
power is turned on if the power source is not connected to the correct
pins.
Summary of Contents for TPC-100W Series
