Safety Instructions
1.
Read these safety instructions carefully.
2.
Keep this User Manual for later reference.
3.
Disconnect this
equipment from
any AC outlet before cleaning. Use a damp
cloth. Do not use liquid or spray detergents for cleaning.
4.
For plug-in equipment, the power outlet socket must be located near
the
equipment and must be easily accessible.
5.
Keep this equipment away
from humidity.
6.
Put this equipment on a reliable surface during installation.
Dropping it or letting
it
fall may
cause
damage.
7.
The
openings
on the enclosure are for air convection. Protect the equipment
from overheating. DO NOT COVER THE OPENINGS.
8.
Make sure the voltage of
the power
source is correct
before
connecting the
equipment to the power
outlet.
9.
Position the power cord so that people
cannot step on it. Do not place anything
over the power cord.
10.
All cautions and warnings on the equipment should be noted.
11.
If the equipment is not used for a long time, disconnect it from the power source
to
avoid damage by transient overvoltage.
12.
Never pour any liquid into an opening. This
may cause fire or electrical shock.
13.
Never open
the equipment. For safety reasons, the equipment should
be
opened only by qualified service
personnel.
14.
If one of the following situations arises, get the equipment checked
by service
personnel:
15.
The
power cord or plug is damaged.
16.
Liquid
has penetrated into the
equipment.
17.
The
equipment has been exposed to moisture.
18.
The equipment does not work well,
or you cannot get it to work according to the
user's manual.
19.
The
equipment has been dropped and damaged.
20.
The equipment has obvious signs of breakage.
21. DO NOT LEAVE THIS EQUIPMENT IN AN ENVIRONMENT WHERE THE STORAGE
TEMPERATURE MAY GO BELOW -30° C (-22° F) OR ABOVE 70° C
(158° F). THIS COULD DAMAGE THE EQUIPMENT. THE EQUIPMENT SHOULD
BE IN A CONTROLLED ENVIRONMENT.
Operating temperature: 50° C
22.
CAUTION: DANGER OF EXPLOSION IF BATTERY IS INCORRECTLY
REPLACED. REPLACE ONLY
WITH THE SAME OR EQUIVALENT TYPE
RECOMMENDED BY THE MANUFACTURER, DISCARD USED
BATTERIES
ACCORDING TO THE MANUFACTURER'S INSTRUCTIONS.
23.
The
sound pressure level
at the
operator's position according to IEC 704-1:1982
is no more than 70
dB (A).
DISCLAIMER:
This set of instructions
is given according to IEC 704-1. Advantech
disclaims all responsibility for the accuracy of any
statements contained herein.
v
TREK-550 User Manual
Summary of Contents for TREK-550
