Advantech TREK-550, Manual

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not 
cause harmful interference and (2) this device must accept any interference received, including interference that may cause 
undesired operation. “Complies with CANADA RSS-210 

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. 

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment 

generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may 

cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular 

installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning 

the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 

-Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment

into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV

technician for help.   

b. FCC Part 15.21 information for user 
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your 
authority to operate the equipment.   

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference and (2) this device must accept any interference received, including interference that may cause 
undesired operation 

  Notes and Warnings to the User and Installer:  Caution: 

           This Installation Guide is intended for use by the professional wireless LAN system installer. 

                   The device cannot be sold retail, to the general public or by mail order. It must be sold to dealers or have strict marketing control. 

Who Should Use this Guide: 

Installation of this device should be accomplished only by a qualified wireless LAN system installer who is: -Knowledgeable of the 

use, installation and configuration procedures and associated networking   components.

-Knowledgeable of each system component’s equipment User and Installation Guide. 

-Knowledgeable  of  the installation and configuration procedures for the site’s network infrastructure system and wiring.   

-Knowledgeable of the installation procedures, safety, and code requirements for the site’s antenna, antenna mast, 

antenna cabling, and installation. 

We highly recommend that the antenna installation be performed by a qualified antenna installation professional.

Users should not attempt to make such connections themselves, but should contact the appropriate electrical inspection authority, 

or  electrician, as appropriate. 

 Only the approved antenna types may be used with this transmitter

FCC RF Radiation Exposure Statement: 

1.This Transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. 

2.This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. 

This equipment should be installed and operated with a minimum distance of 20 centimeters between the radiator and your body.