2/2
www.aec.com.tw/LT-48UXP-UpgradeKit-Setup.htm
12. Make sure that the 48 pin ZIF programmer socket is firmly seated in its socket on the upper PCB.
13. Run the new software release, and perform a self test of the programmer. If no error is encountered, the upgrade has been
successfully completed.
14.
Interface : use either the USB or DB-25 parallel port connector (higher speed than USB due to heavy handshaking in the
programming and verifying modes). Setup the PC to run the parallel port in
EPP
mode (EPP mode recommended).
For more information, please contact:
Advantech Equipment Corporation
Fl. 7, No. 98, Ming-Chuan Road, Shing-Tien City, Taipei, Taiwan, R.O.C.
Tel: 886-2-2218-2325
FAX: 886-2-2218-2435
Print Back
