background image

FCC Warning 

 

This equipment has been tested and found to comply with the limits for a class B digital device, 

pursuant to Part 15 of the FCC Rules. These limitations are designed to provide reasonable 

protection against harmful interference in a residential installation. This equipment generates, 

uses and can radiate radio frequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. However, there is no 

guarantee that interference will not occur in a particular installation. If this equipment does cause 

harmful interference to radio or television reception, which can be determined by turning the 

equipment off and on, the user is encouraged to try to correct the interference by one or more of 

the following measures:   

*Reorient or relocate the receiving antenna. 

*Increase the separation between the equipment and receiver. 

*Connect the equipment into a different outlet from that the receiver is connected. 

*Consult your local distributors or an experienced radio/TV technician for help. 

*Shielded interface cables must be used in order to comply with emission limits 

Changes or modifications to the equipment, which are not approved by the party 

responsible for compliance could affect the user's authority to operate the equipment. 

 

Copyright _ 1999 All Rights Reserved. 

Company has an on-going policy of upgrading its products and it may be possible 

that information in this document is not up-to-date. 

Please check with your local distributors for the latest information. 

No part of this document can be copied or reproduced in any form without written 

consent from the company. 

 

Trademarks: 

 

All trade names and trademarks are the properties of their respective companies.   

 

 

 

 

 

 

 

 

Summary of Contents for ANS-800P






Reviews: