- 7 -
www.advateklights.com
PixLite R2F-S User Manual V200702
Figure 5: Connecting Receivers to Transmitter
3.4 - Connecting Pixel LEDs
The pixel lights are connected directly via the 2 pluggable screw terminal connectors
on the rear of the unit. Each connector is labelled with its output channel number (1-2)
and on the top of the lid the pin-out is clearly marked. Simply wire your lights into
each screw terminal and then plug them into the mating sockets.
The cable length between the output and the first pixel should not exceed 15m.
shows the pin-out of the pixel output connectors.
