©2006 Adventistsat.com
16
Attach the LNBF Arm to the Elevation
Bracket. Assemble the Elevation
Bracket and Post Clamp. Most
installations in the US and Canada will
use Elevation Scale A type assembly.
Mexico installations will usually use
Elevation Scale B assembly.
The Post Clamp has two holes drilled. One hole is stamped with an
A and the other with a B. Assemble the Elevation Bracket to the Post
Clamp using either the hole stamped A if the Dish Elevation Angle is
between 20 - 50 degrees or the hole stamped B if the elevation angle
is 50 – 90 degrees. The dish has been
correctly assembled for Measuring the
Dish Elevation Angle using the A Scale
if an upside letter B is visible stamped on
the Post Clamp. If an upside down letter
A is visible on the Post Clamp, the dish
has been assembled to use Scale B for
measuring the Elevation Angle.
US and Canada
Mexico
After verifying the reflector is not
warped, mount to the Elevation
Bracket.
