©2006 Adventistsat.com
36
Select
11822
by pressing
VOL/LEFT
or
VOL/RIGHT
. (This
is 3ABN, the strongest transponder on the satellite).
Locate the satellite and peak
Signal Quality
reading by setting
the dish elevation and panning the dish side to side. As the dish is
directed at any one of the 30+ satellites visible over North America,
the signal strength reading will rise and fall. Only when the dish is
aimed at the correct satellite will the Signal Quality reading increase
above 10%.
Note: Signal Level is not important at this time. If no
Signal Quality is detected, increase or decrease the elevation by
one degree and sweep once again. The elevation may need to be
adjusted up to +/- 5 degrees depending on the accuracy of the post
leveling and mechanical tolerances. Signal Quality must be at least
90% + on this channel.
Press
VOL/RIGHT
arrow to place the receiver on
12020
.
(This is the LLBNchannel, a weaker transponder).
Verify the Quality reading is
70% +
. If not, peak Quality
reading by fine tuning the dish angles.
Press
EXIT
button
3 times
to exit the menus. Verify that all
AMC4 channels are being received.
The installation is complete!
15.
16.
17.
18.
19.
20.
Installer Tip:
If you are having trouble locating the satellite,
remove the AdventistSat LNBF from the clamp and install a DirecTV
LNBF into the LNBF position. Locate the DirecTV 101w satellite
with a meter or DirecTV receiver. Replace the AdventistSat LNBFs
into the clamp. The dish is now roughly aimed and will only require
fine tuning for optimal reception of the linear satellite AMC4.
Set the Channel list to only display the AMC4 channels:
Press
CH LIST
button
Press the (Orange)
LIST
button.
Press
VOL ◄
until satellite name AMC4/KU is displayed.
Press
EXIT
to view or listen to available AMC4 channels.
