6
OPERATING INSTRUCTIONS
CHARGING
1.
Plug 240V Charger into a suitable the mains socket
2. Insert the pin of the charger into the housing of the 12V
Lithium Battery
3.
The battery will take 3-5 hours to charge.
INFLATING TYRES
1. Loosen the attachment lock approximately 3 rotations
counter-clockwise (see Fig 3). Do not remove lock completely.
2. IMPORTANT: Insert the air hose with threaded connector into
the attachment until it can go no further. (See Fig 4).
3. Tighten attachment lock clockwise until hand tight.
4.
Press the Power button below the LCD display to turn on
(See fig 5).
5.
Then choose desired pressure format (PSI, BAR, KPA) press
the power button continuously until desired format displays.
6.
Screw the threaded connector onto tyre’s valve stem quickly.
When connected, the gauge will show current tyre pressure.
7.
Press “+” or “-“ to set desired pressure level. Once set, wait
a few seconds until current tyre pressure displays. NOTE:
Always check and follow the manufacture’s recommended
pressure, usually located on the door jamb of the vehicle.
8.
Being sure trigger lock is in unlock position, press the trigger.
9.
The air compressor will begin to inflate the tyre to the set
pressure level and then shut off automatically when reached.
10. When done, press the trigger once to turn off and slide the
trigger lock to the lock position.
11.
Remove the thread connector from the tyre quickly and
replace valve stem cap on tyre, if required.
WARNING:
Connector may be hot. Use caution when removing.
NOTE:
To avoid over-inflation of tyres, please check the
recommended tyre pressure in the vehicle’s owner’s manual.
Summary of Contents for AKAC-LITAIR 01
Page 4: ...4 INCLUDED IN THE BOX...
