10
2. OVERLOAD INDICATOR LIGHT
The overload indicator light will blink when an overload of
a connected electrical device is detected. Decrease the
load to below the rated output and the overload indicator
light will go off.
When an overload is detected, the inverter unit overheats,
or the AC output voltage decreases, the overload
indicator light will come on and the electronic breaker will
then activate, stopping power to the generator in order
to protect the generator and any connected electrical
devices. The output pilot light (Green) will be off, the
overload indicator light will turn RED, & the engine will
stop. If a overload occurs the following steps will need to
be done:
a. Turn off any connected electrical devices
b. Reduce the total wattage of connected devices
c.
Check for blockages in the cooling air inlet, muffler
air exhaust pipe opening and the control unit before
restarting engine.
OVERLOAD
Summary of Contents for AKGE-2.2KGE 01
Page 18: ...18 9 WIRING DIAGRAM 2200I 240V...
