Adventure Kings AKGE-2.2KGE 01, User Manual

13

ENGINE OIL REPLACEMENT

1.  Place the generator on a level surface and warm up 

the engine for several minutes. Stop the engine and 
turn the fuel petcock knob to the OFF position. Turn 
the fuel tank cap air vent knob counterclockwise to 
the CLOSED position. 

2.  Loosen the screw and remove the cover.
3. 

Remove the oil filler cap.

4.  Place an oil pan under the engine. Tilt the generator 

to drain the oil completely.

5.  Return the generator to a level surface. 
6.  Add engine oil until it reaches the upper level.
7. 

Install the oil filler cap.

8.  Install the cover and tighten the screw
•  Recommended engine oil: 

(see page 17) 

API Service “ SJ” 

CAUTION

•  Be sure no foreign material enters the crankcase.
•  Do not tilt the generator when adding engine oil. This 

could result in overfilling and damage to the engine 

AIR FILTER

Maintaining an air filter is very important. Dirt and debris 

entering through improperly installed, improperly serviced, 

or inadequate filters can damage and wear out engines 
prematurely. Always keep the filter clean.

1.  Remove the cover. 
2. 

Remove the air filter.

3. 

Wash the filter in a solvent and dry.

4. 

Oil the filter and squeeze out excess oil. The filter 

should be wet but not dripping.

5. 

Insert the filter into the cover.

6.  Install the cover.

CAUTION

• 

The engine should never run without the filter; 
excessive piston and/or cylinder wear may result.