7
7
ATTACHING MOUNTING CHANNELS
1. Remove the Roof Top Tent from the carton and place on a clean surface. Observe
the top surface. If it has four holes in the center area of the base, then this is the
side which will receive the mounting channels. Otherwise you are looking at the
surface which will receive the ladder. Open tent to gain entrance to interior and
remove contents.
Contents:
Ladder – 1 pce, PVC cover – 1 pce, Annex room – 1 pce, Rod for window – 6 pces,
Mounting channel – 2 pces, Mounting accessories – 1bag.
2. After removing the contents, close the Roof Top Tent, so the channel mounting
surface is facing upward, then move the cap of holes (side with 4 holes).
3.
Using the four supplied
40mm Steel M6 bolt
, slide your hand between the base
and mattress, and insert the bolts with washers into the pre-drilled holes.
4.
Place mounting channels on exposed bolts. For side mounted orientation, ensure
the mounting channels are perpendicular to hinge side. For rear mounted
orientation, ensure the mounting channels are parallel to hinge side.
5.
Slide the
M6 Nylock Nut
into the inner slot in the center of the mounting channels,
until they are aligned with the bolts sticking through the base. Tighten the bolts
firmly from below, using the supplied 10mm wrench. If you chose a
rear
mounted
orientation, you will notice that the mounting channels extend (20cm) beyond the
edges of the base. You will need to mark each channel where they extend beyond
the tent base and cut the mounting channels so they fit within the tent base. Fasten
mounting channels to base as described above.
J001157 - Adventure Kings RTT Manual-Insert2.indd 7
7/05/2014 10:11:34 a.m.
AK_RTT_Manual.indd 7
29/08/2014 12:24 pm
