T
RUCK
C
AMPER
O
WNER
’
S
M
ANUAL
© ALP (Adventurer Limited Partnership).
21
All Rights Reserved
CAUTION:
This procedure should be used in an
emergency only.
OPERATING THE ELECTRIC SLIDE OUT
The switch for the slide out is located just inside the entry door
close to the floor for your convenience.
Locate the slide
on/off switch
right next to the slide operation switch (on some
models)
Switch to the on position.
Hold slide operation button in the out position until the slide is fully out.
To bring the slide back in, hold the button in the in position until the slide is fully
closed.
Slide-Out Manual Operation (Happi-Jac Slides)
If the slide fails to operate because of a slide motor malfunction,
dead battery, etc. please do the following:
Locate the
slide on/off switch
right next to the slide
operation switch (see above).
Switch to off position to enable manual mode
Remove the plastic cap at rear of camper on the same
side as the slide room
install slide crank onto socket of motor turning crank until slide is all the way in. (some cases
you may have to reach under the slide to disengage the slide brake lever)
return slide on/off switch to the on position
CAUTION:
Always make sure the camper is
in a reasonably level position before putting
slide out, damage can occur in extreme cases.