600VA RM (2U)
2.
I
NSTALLATION
Inspect the UPS upon receipt. The packaging is recyclable; keep it for reuse or be disposed
of properly.
2.1 Placement:
Install the UPS in a protected area with adequate flowing air and free of
excessive dust. Do not operate the UPS where the temperature and humidity is out of the
specified limits.
2.2 Connect Computer Interface (optional):
UPS-MON series software (or other
power management software) and an interface kits can be used with this UPS. Use only kits
supplied or approved by the manufacturer. If used, connect the interface cable to the 9-pin
computer interface port on the back panel of the UPS.
Note: Computer interface connection is optional. The UPS works properly without a
computer interface connection.
CAUTION
: Use only factory supplied or authorized UPS monitoring cable!
2.3 Connect external battery pack (optional):
Before connecting, make sure the
external battery pack and the connector cable are compatible.
Note: External battery connection is not necessary. The UPS works properly
without external battery pack connection. (Except AL models only)
CAUTION
: Use only factory supplied or external battery connection cable!
2.5cm (1 inch)
