3
3.2
HDD Installation
1.
Loosen the screws on the rear panel and side panel and remove the upper cover.
Rear Panel
Side Panel
2.
Insert 2 screws into the disk and tighten the screws halfway.
3.
Slide the disk into place from A to B, and fix the 4 screws to secure the hard disk.
4.
Connect the power cables and data cables.
5.
Put the cover back in place and tighten the screws.
4
Startup and Shutdown
Make sure the cables are connected correctly and the device is grounded properly. Use a power supply
that meets requirements.
4.1
Startup
Connect the device to power and turn on the power switch.
4.2
Shutdown
Click
>
Shutdown
on the screen toolbar in live view page.
CAUTION!
Do not disconnect power when the NVR is operating or shutting down.
Screws
HDD