96-8006123_11-03-2021
Information subject to change
9
8302 OPERATOR’S MANUAL – SECTION 3
Figure 3.6 – Closeup of AC Mains Barrier Strip for
120V or 230/240VAC wiring
ELECTRIC SHOCK HAZARD.
AC supply potentials can be lethal. Inlet
cover must remain installed at all times
to protect against HAZARDOUS LIVE
VOLTAGES
WARNING
Do not disconnect or disable the protective
grounding connection. Doing so causes a poten
-
tial electrical shock hazard.
Connect the AC supply to the three-terminal bar
-
rier strip located on the amplifier back panel (see
Figures 3.6 and 3.7
).
Install AC inlet cover prior to connecting to the sup
-
ply source. See
Figure 3.8.
Figure 3.8 – AC Inlet Safety Cover
Start-up Procedure
1.
Turn down the level of your signal source.
2.
Place the back-panel breaker switch in the
ON position.
3.
Switch the front-panel Power switch to the
ON position to energize the amplifier.
4.
Wait until the Run/Standby indicator turns
solid green.
5.
Adjust your input signal level to achieve
the desired output level.
Figure 3.7 – Closeup of AC Mains Barrier Strip for
208VAC wiring
Summary of Contents for 8302
Page 2: ......