Making Connections
Before beginning the installation of your amplifier, check the
following:
Remove all power from the unit. Do not have the AC cord
plugged in.
Turn input level control down (fully counter clockwise).
The input and output jacks are located on the back panel. Use care in
making connections, selecting signal sources, and matching loads.
During hookup take the following precautions:
1.
Use only shielded cable on inputs.
The higher the density of the
shield (the outer conductor), the better the cable. Spiral wrapped shield
is not recommended.
2.
The output wire and connectors should be heavy enough
to carry
the intended current to the load.
3.
Use good quality connectors
with proper strain relief.
Do not use connectors that have any tendency to short circuit.
Do not use connectors that can be plugged into AC power
receptacles.
4.
Keep unbalanced input cables as short as possible.
Avoid
lengths
greater than 10 feet.
5.
Do not run signal
(input)
cables together with high level wiring
such as load (output) wires or AC cords (lowers most hum and noise).
6.
Do not short the ground lead of an output cable to the input
signal ground.
Oscillations may result.
7.
Operate the amplifier from proper AC current.
Supply voltage
must be 50 to 60 Hz and no more than 10% above or below the
selected line voltage. Failure to comply with these frequency limits
may damage the unit and result in unreliable operation.
Page 17
Summary of Contents for LVC 5050
Page 23: ...Notes Page 23 ...
Page 24: ...Notes Page 24 ...
