:: Shocks Build - Bag M-MM - Step 4
91304
12mm
threaded
collar
91304
12mm
threaded
collar
o-ring
x4
x4
91310
12mm shock
spring cup
(5mm offset)
91332
12mm front
spring, Red
(3.90lb)
91336
12mm rear
spring, Green
(2.00lb)
Front:
4.5mm
Rear:
1.6mm
Build x2 front and x2 rear shocks
Racers Tip:
Use your finger to rub
shock oil on the o-ring for
smoother adjustment!
19
:: Shocks Build - Bag M-MM - Step 5
6472
Shock
mount nut
6925
4-40x1/2
shcs
6925
4-40x1/2
shcs
6472
Shock
mount nut
91447
Shock
bushing
ball
91447
Shock
bushing
ball
x2
x2
x2
x2
x2
x2
9mm
Offset
5mm
Offset
0mm
Offset
:: Shocks Build - Bag M-MM - Step 3
x4
91449
12mm
shock cap
Step 9-10
Step 8
Step 6-7
Step 4-5
Front Shock: 35 wt
Rear Shock: 35 wt
Step 2-3
Shock Bleeding Steps:
1.
Before assembly, get each bleed
screw and thread it 1-2 turns into the
shock cap. This will make installation
easier when you are bleeding your
shocks.
2.
Pull shock shaft down completely.
3.
Fill shock body 3/4 full with silicone
shock fluid.
4.
Slowly move the shock shaft up and
down to remove air from under the
piston.
5.
Wait for bubbles to come to surface.
6.
Fill shock body to top with silicone
shock fluid.
7.
Place a drop of oil in the cap and on
cap threads.
8.
Install cap (without bleed screw) and
tighten completely.
9.
Slowly compress shaft all the way to
bleed excess silicone shock fluid out
the hole in the cap (use rag around-
shock to catch excess fluid).
10. Install M2x4mm button head screw
until snug while shaft is fully com-
pressed.
Shock oil
#5429
Shock oil
#5429
31510
M2x4mm
bhcs
x4
Summary of Contents for B44.3 Factory Team
Page 1: ......