AE RC10B6, Instruction Manual

15

:: Bag 20-22 - Step 4

:: Bag 20-22 - Step 3

91304

12mm 

Threaded 

Collar 

91304

12mm 

Threaded 

Collar 

O-ring

x4

x4

91310

12mm shock 

spring cup

(Front - 5mm

Rear - 0mm)

91333

12mm Front 

Spring, Orange 

(4.05lb)

91339

12mm Rear 

Spring, Blue 

(2.30lb)

Front: 

5.00mm

Rear: 

1.00mm

Build x2 front and x2 rear shocks

Racers Tip:

Use your finger to rub 

shock oil on the o-ring for 

smoother adjustment!

#91310 12mm Shock Spring Cups

0mm

5mm

9mm

Front Shock: 37.5 wt

#5433

Rear Shock: 30 wt

#5422

Shock fluid

Step 9-10

Step 8

Step 6-7

Step 4-5

Step 2-3

Shock Bleeding Steps:

1. 

Before assembly, get each bleed 

screw and thread it 1-2 turns into the 

shock cap, then remove the screw.  

This will make it easier when you are 

bleeding your shocks.

2. 

Pull shock shaft down.

3. 

Fill shock body 3/4 full with silicone 

shock fluid.

4. 

Slowly move the shock shaft up and 

down to remove air from under the 

piston.

5. 

Wait for bubbles to come to surface.

6. 

Fill shock body to top with silicone 

shock fluid.

7. 

Place a drop of oil in the cap and on 

cap threads.

8. 

Install cap (without bleed screw) and 

tighten completely.

9. 

Slowly compress shaft all the way to 

bleed excess silicone shock fluid out 

the hole in the cap (use rag around 

shock to catch excess fluid).

10.  Install M2x4mm button head screw 

until snug while shaft is fully com-

pressed.

91492

M2 x 4mm 

BHCS

Stroke

Front: 20mm

Rear: 28mm

Stroke

Shock fluid

:: Bag 20-22 - Step 2

91480

12x23mm V2 

Shock Bodies 

(front)

91481

12x27.5mm 

V2 Shock 

Bodies (rear)

91495

V2 Shock 

Hat Bushing

91495

V2 Shock 

Spacer

91493

X-Ring

31327

VCS3 Shock 

Bottom Cap

31327

VCS3 Shock 

Bottom Cap

O-Ring

91491

12mm 

Shock  Cap 

O-Ring

x2

x2

#1105

green slime

Lightly rub shock oil 

on the o-ring before 

installation!

There is a short and 

long shock eyelet.

Front shocks use 

the short eyelet, 

rear shocks use 

the long eyelet.

Racers Tip:

Coating the o-rings 

with green slime 

(#1105) helps seal 

& reduce o-ring 

swell! 

Green slime 

not included in kit!

!

!

#1105

green slime

91721

Shock Eyelet

Front Shocks - Long

Rear Shocks - Short

91721

Shock 

Pivot Ball

Short / Long