14
:: Shocks Build - Bag I - II - Step 4
Front Shock: 35 wt
Rear Shock: 35 wt
Shock fluid
#5429
:: Shocks Build - Bag I - II - Step 3
#1105
green slime
91448
Shock
eyelet
91448
Shock
Pivot Ball
91481
12x27.5mm V2
Shock Bodies
(front)
91483
12x36mm V2
Shock Bodies
(rear)
91491
V2 Shock
Hat Bushing
91491
V2 Shock
Spacer
5407
O-Ring
31327
VCS3 Shock
Bottom Cap
31327
VCS3 Shock
Bottom Cap
O-Ring
91491
12mm
Shock Cap
O-Ring
x2
x2
#1105
green slime
Lightly rub shock oil
on the o-ring before
installation!
Racers Tip:
Coating the o-rings
with green slime
(#1105) helps seal
& reduce o-ring
swell!
Green slime
not included in kit!
:: Shocks Build - Bag I - II - Step 2
!
91304
12mm
threaded
collar
91304
12mm
threaded
collar
o-ring
x4
x4
91310
12mm shock
spring cup
(9mm offset)
91330
12mm front
spring, Blue
(3.60lb)
91337
12mm rear
spring, White
(2.10lb)
Front:
11.00mm
Rear:
11.50mm
Build x2 front and x2 rear shocks
Racers Tip:
Use your finger to rub
shock oil on the o-ring for
smoother adjustment!
Step 9-10
Step 8
Step 6-7
Step 4-5
Step 2-3
Shock Bleeding Steps:
1.
Before assembly, get each bleed
screw and thread it 1-2 turns into
the shock cap. This will make it easier
when you are bleeding your shocks.
Remove screw.
2.
Pull shock shaft down.
3.
Fill shock body 3/4 full with silicone
shock fluid.
4.
Slowly move the shock shaft up and
down to remove air from under the
piston.
5.
Wait for bubbles to come to surface.
6.
Fill shock body to top with silicone
shock fluid.
7.
Place a drop of oil in the cap and on
cap threads.
8.
Install cap (without bleed screw) and
tighten completely.
9.
Slowly compress shaft all the way to
bleed excess silicone shock fluid out
the hole in the cap (use rag around
shock to catch excess fluid).
10. Install M2x4mm button head screw
until snug while shaft is fully com-
pressed.
31510
M2 x 4mm
BHCS
Stroke
Front: 26.0mm
Rear: 34.5mm
Free Length
Front: 86.25mm
Rear: 103.00mm
Free
Length
Stroke
Shock fluid
#5429
#91310 12mm Shock Spring Cups
0mm
5mm
9mm
Summary of Contents for RC10T5M
Page 1: ......