UPS IST7 Series (60K-200K)
User Manual
3 Installation
55
Figure3-19
Install expansion bolts
The expansion tube shouldn’t be higher than the ground, which is to avoid affecting the installation.
The exposed height of expansion bolt must be within 50mm.
Step 4
Move the UPS from wooden bracket to the ground by forklift, and align the bottom installation hole
with the expansion bolt, and screw the bolts.
Step 5
Reinstall the bottom cover plates, as shown in Figure3-20.
Figure3-20
Install the bottom cover plates
----End
3.4.3 Optional Accessory Installation
If the SNMP card or expansion card is a independent product, install it in the installation position.
Summary of Contents for IST7 Series
Page 1: ...UPS IST7 60 200kVA Series User Manual www aecups com ...
Page 2: ......