User Manual 1-3kVA Rev. 9
- Page 24 of Total 30 -
4. Maintenance
4.2 Replacing the New Battery
This UPS contains potentially hazardous voltages. Do not open the UPS. There are no
user-serviceable parts inside.
4.3 Testing the New Battery
Start up the UPS with load added. Press the “Select-up” & “Enter” buttons for three
seconds to activate the self-test. If the UPS switches back to Normal Mode after 10 seconds,
then the batteries are good. If it does not, then please replace the battery or contact your
sales representative for assistance.
4.4 Recycling the Used Battery
Do not discard the UPS and batteries with normal household/industrial waste. Contact your
local recycling or hazardous waste center for information on proper disposal of used battery
pack and batteries.
Consider all warnings, cautions, and notes before replacing batteries.
Batteries can present a risk of electrical shock and high short circuit
current. The following precautions should be observed when working on
batteries:
Î
Remove watches, rings, and other metal objects.
Î
Use tools with insulated handles.
Î
Do not lay tools or metal parts on top of batteries.
Î
Do not attempt to alter any battery wiring or connectors. Attempting
to alter wiring can cause injury.
Î
Do not dispose of batteries in a fire. The batteries may explode.
Refer to your local codes for disposal requirements.
Î
Do not open or damage the battery or batteries. Released electrolyte
is harmful to the skin and eyes and it is toxic.
Î
When replacing the battery, use the same number and voltage(V)
/capacity(Ah).
Î
Avoid harm to the environment: proper disposal or recycling of the batteries is
required. Refer to local regulations for disposal requirements.
Î
NEVER dispose of the battery in a fire. They may explode.
Î
Do not open or damage the battery. The contents (electrolyte) may be
extremely toxic. If exposed to electrolyte, then wash immediately with plenty
of water.
Î
Avoid charging in a sealed container.
Î
Never short circuit the battery. When working with batteries, remove watches,
rings and other metal objects. Only use insulated tools.
Î
The following precautions should be observed when working on batteries:
•
Remove watches, rings, and other metal objects.
•
Use tools with insulated handles.
Î
Make sure that there is no voltage before touching the batteries.
