aee.com
17
2.7 Landing Gear Operations
(1) Pull the landing gear (Fig. A) up to erect it until you hear a click sound.
(2) Press the retract button (Fig. B) and retract the landing gear.
,OM'
,OM(
Note:
there are two types of landing gears: automatic retractable landing gear (
Condor Elite
) and manual
retractable landing gear (
Condor Advanced
).
2.8 Install the Optical Flow Module (Only for Condor Elite)
Follow the steps below to install the optical flow module:
(1) Fit the right fastener of the optical flow module into the right locking seat of the UAV.
(2) Press and hold the button of the left fastener of the optical flow module, fit the pin and leftfastener
of the optical flow module respectively into the pin hole and left locking seat of the UAV, press the
leftfastener down, and then release the button.
(3) Pull the optical flow module up lightly to check whether it is installed reliably. If not, repeat step (1) and
(2) until it is installed reliably.
(4) Do not plug or remove the Visual module and ultrasonic module when the UAV is powered on.
(5) The figure 12 below shows the installation effect.
Fig. 12
