74
Fig. 9
Fitting the cold air inlet - Fig. 9
This is not applicable when the hood is used in re-circulation mode.
The hood can be fitted with a cold air inlet (Fig. 9). The cold air inlet
consists of two valves fitted inside the hood flue duct. If the hood is the
only ventilation system in the kitchen, the extremity of the valves
leading to the outside must be cut off and removed. Bend the valves
slightly so that the pins fit into the slots provided in the hood flue duct.
Make sure the criss-cross side of the valves is facing upwards.
Push each valve with a pencil or similar object; the valves should open
without any resistance. In the event of friction, make sure each valve
has not been installed upside down and that none of the pins have
slipped out of their slot.