If you connect the water drain hose to a trap spi
-
got under the sink, remove the plastic membrane.
If you do not remove the membrane, remaining
food can cause a blockage in the drain hose spigot
The appliance has a security feature to prevent
dirty water going back into the appliance. If, the
spigot of the sink has a 'non-return valve', this
valve can cause the appliance to drain incorrectly.
Remove the non-return valve.
CAUTION!
Make sure that the water couplings are tight to prevent water leakage.
Ensure that hoses are not crushed or kinked under
or behind the appliance.
Once connected the inlet hose to the water tap,
turn the tap on and check that there are no leaks.
Electrical connection
WARNING!
Safety standards require the appliance to be earthed.
Prior to using the appliance for the first time, ensure that the rated voltage and type of
supply on the rating plate match that of the supply where the appliance is to be installed.
The fuse rating is also to be found on the rating plate.
Always plug the mains plug onto a correctly installed approved socket.
Do not use multi-ways plugs, connectors and extension cables. This can constitute a fire
hazard through overheating.
If necessary, have the domestic wiring system socket replaced. If the mains cable has to be
replaced, contact your local Customer Care centre.
The mains plug must be accessible after the appliance has been installed.
Never unplug the appliance by pulling on the cable. Always pull the plug.
Test the appliance. Run a quick washing programme and ensure that the appliance fills
with water, washes and drains with no leaks.
The manufacturer accepts no liability for failure to observe the above safety precautions.
Electrical connection
31
