www.aeg-automotive.com
30
Installing the reversing camera
•
Verify the battery of the reversing
camera is fully charged�
•
ensure the slide switch (7) at the
back of the camera is in the „on“
position before installing�
•
If the device will not be used for
an extended period, switch off the
device with the slide switch (7) to
prevent battery damage due to deep
discharging�
•
The monitor shows the battery
charge when on�
The mounting bracket (1) may need to
be turned depending on if the reversing
camera is installed above or below the
number plate�
1� loosen the screws at the back to
turn the mounting bracket�
2� Turn the mounting bracket (1) 180°�
3� fix the mounting bracket (1) with
the screws�
Attention!
Due to differences in technical and
design-related vehicle types, these
instructions for use do not apply to all
vehicle models�
1� remove the number plate from its
bracket�
2� Unscrew and remove the number
plate holder�
3� Centre the mounting plate behind
the number plate holder�
7� „on/off“ slide switch (back)
8� lCD monitor
9� „Wake/standby“ button
10� „Menu“ button
11� „Up“ button
12� „Power/enter“ button
13� „Down“ button
14� Pairing pin
15� Monitor arm with suction cup
16� 1 Monitor cable with 12 V plug
17� Usb cable
InsTallaTIon
Charging the battery pack
•
The reversing camera is powered by
the integrated battery pack, which is
charged via the built-in solar cells or
the Usb port�
•
The storage battery should be fully
charged prior to first use.
•
If the battery is drained due to lack
of sun exposure, also charge via the
Usb port�
1� open the rubber cover at the side�
2� Plug the Usb cable into the Usb
port�
3� Connect the other end of the Usb
cable to a Usb power supply�
4� The charging process will start
automatically� The charging time is
approx� 6-7 hours�
Summary of Contents for 10997
Page 20: ...www aeg automotive com 20 ...
Page 117: ......
Page 118: ......
Page 119: ...Made in China ...