English 31
2� Press the suction cup against the
windscreen and push the locking
lever toward the suction cup�
3� Insert the monitor mount of the
monitor arm (15) into the designated
opening at the back of the monitor�
4� slide the monitor bracket up until it
locks in place�
5� open the locknut and adjust the
monitor to a comfortable angle�
Then tighten the locknut again to
fix the monitor.
6� Connect the monitor cable (16) to
the monitor and the 12 V vehicle
socket� route the monitor cable
so it does not impair or jeopardise
the safety of the vehicle and its
occupants�
•
remember the vehicle‘s battery will
be discharged when the vehicle is not
running�
oPeraTIon
Warning!
Do not operate the monitor whilst driv-
ing, as this distracts from traffic. Main
-
tain your focus on driving and traffic.
attention!
In extremely bright conditions the
monitor will take a few seconds to ad-
just to the light conditions� Wait for the
image to stabilise before reversing�
Attention!
The location of the camera brackets
may not impair the functionality of the
license number light! If it impairs the
license number light mount the camera
on the opposite side�
4� attach the mounting plate and the
number plate holder to the vehicle�
5� attach the number plate�
Adjusting the reversing camera
The reversing camera can be swivelled
in one direction�
1� To adjust the reversing camera,
loosen the screws at the bottom of
the reversing camera�
2� swivel the camera into the desired
position�
3� Tighten the screws�
Installing the LCD monitor
Attention!
The location of the monitor may not im-
pair the visibility of the driver! further,
do not impair the functionality and
operation of equipment, control units
and systems inside the vehicle� follow
applicable laws and safety regulations
for vehicles!
1� Clean the area of the windshield
where you would like to attach the
suction cup base�
Summary of Contents for 10997
Page 20: ...www aeg automotive com 20 ...
Page 117: ......
Page 118: ......
Page 119: ...Made in China ...
