www.aeg-automotive.com
32
“Orientation” menu
This setting allows you to install the
camera inverted and still see the image
correctly�
1� select the respective camera (cam-
era 1 or camera 2)�
2� Press the “enter” button (12) to
invert the image�
“Setup” menu
Pairing
This menu is used to pair the camera
with the monitor� The device can be
connected to two cameras�
1� select the camera you want to pair
(“PaIr1” for camera 1 or “PaIr 2” for
camera 2)�
2� Hold the pairing button (2) with
the included pairing pin (14) or a
paper-clip until the pairing has been
confirmed and the monitor shows
the camera image�
Time-Out
This menu is used to configure how
long the camera image will be displayed
after pressing the “standby” button�
•
30 sec�
•
45 sec�
•
60 sec�
Information about use
•
you may have to turn the ignition
to activate the vehicle’s 12 V socket�
Please refer to the owner’s manual
for your vehicle� Contact a specialised
shop if you are unsure�
•
Do not cover the device during use
and ensure proper ventilation�
Switching the monitor on/off
1� Press the “standby” button (9) to
activate the screen�
2�
Press the button again to switch off
the screen�
Operating the monitor
1� Press the “Menu” button (10) to
open the menu�
2� Use the “Up” (11) and “Down” (13)
buttons to select a symbol or set-
ting�
3� Press the “enter” button (12) to con-
firm a selection or open a submenu.
4� Press the “Menu” button (10) to go
back or exit the menu�
“Screen settings” menu
1� select the respective camera (cam-
era 1 or camera 2)�
2� select a setting:
•
brightness
•
Contrast
•
Colour
Summary of Contents for 10997
Page 20: ...www aeg automotive com 20 ...
Page 117: ......
Page 118: ......
Page 119: ...Made in China ...
