53
Fig. 7
Wall mounting - Fig. 7
• Sign a centerline onto the wall (1).
Fit the template onto the wall (2).
• Fix the drilling template to the wall.
• Make 3 Ø 8mm holes in the wall (3), 2 at upper points, 1 as desired
at lower points.
• Insert the three Ø 8mm expansion plugs into the wall (4).
• Insert 2 5x45 screws (5) but do not tighten them completely, hang
the hood (6).
• Adjust the unit so that it is positioned at a right angle to the wall by
turning the two screws on lower side (7).
• Tighten the 2 upper screws (8).
• From inside the hood, insert the third 5x45 screw into the lower hole
(9) and tighten (10).
2
3
4
4
4
5
5
3
1
6
6
9
8
1cm
5!
10
8
7
7
