11
Wall mounting
●
Fix the drilling template to the wall.
●
Make 3 Ø 8mm holes in the wall 2 at points
I
, 1 as desired at
points
L
.
●
Insert the three Ø 8mm expansion plugs into the wall.
●
Insert 2 5x45 screws at points
I
but do not tighten them
completely.
●
Adjust the unit so that it is positioned at a right angle to the wall
by turning the two support screws
G
.
●
Fit the hood into holes
I
, tighten the 2 screws.
●
From inside the hood, insert the third 5x45 screw into hole
L
.
Fig. 5
5