4
2
Introduction
Extraction mode
●
The hood is supplied as an extractor unit and can also be used with a
filtering function by fitting activated carbon filters (available as an
accessory).
●
The unit features two outlet holes, one of which
A
is located on the
top of the unit while the other
B
is located on the rear.
●
To connect up the hose, you should first fit the bayonet-mounting
flange
C
(Ø120 mm) on the outlet required (if using the top outlet,
fix the flange in place using the screw supplied as shown in
Fig. 1
).
Close off the unused hole using the bayonet fitting caps
D
.
●
Important!
To use the back hole
B
, remove switch
F
from the
top hole.
Fig 2.
A
D
B
C
D
B
A
C
1
