21
Installation
» Fit the cable grommet. For connecting cables
> 6 mm², enlarge the hole in the cable grommet.
Making the water connection
!
Material losses
Carry out all water connection and installation work
in accordance with regulations.
26
_0
2_0
2_0
94
8
» Seal and insert the twin connectors.
!
Material losses
Never use the shut-off valve in the cold water inlet
to reduce the flow rate.
Preparing the back panel
!
Material losses
If you break out the wrong knock-out by mistake, you
should use a new back panel.
D
00000
41
89
6
» Break out the cable grommet knock-out in the
back panel.
Deburr the sharp edges with a file if
necessary.
Installing the appliance
D
00000
41
89
7
» Push the back panel over the threaded stud and the
cable grommet. Pull the cable grommet by the lock-
ing hooks into the back panel using pliers, until both
locking hooks audibly click into place.
» Remove the transport plugs from the water
connections.
»
Press the back panel firmly into place and lock the
fixing toggle by turning it clockwise through 90°.
D
00000
41
92
5
»
Screw the water connection pipes with flat gaskets
on to the twin connectors.
!
Material losses
The strainer must be fitted for the appliance to func
-
tion.
»
When replacing an appliance, check whether
the strainer is installed (see chapter "Mainte
-
nance").
Making the electrical connection
WARNING Electrocution
Carry out all electrical connection and installation
work in accordance with relevant regulations.
WARNING Electrocution
The connection to the power supply must be in the
form of a permanent connection in conjunction with
the removable cable grommet.
Ensure the appliance
can be separated from the power supply by an iso
-
lator that disconnects all poles with at least 3 mm
contact separation.
