appliance into the circular hole on
the bracket. Screw it into the wall.
50 mm
77 mm
A
4.
Check that the anti-tilt protection (A)
fits minimum 20 mm into the hole in
the rear wall of the appliance (B)
when you push the appliance.
13.5
Electrical installation
WARNING!
The manufacturer is not
responsible if you do not
follow the safety precautions
from Safety chapters.
This appliance is supplied without a main
plug or a main cable.
13.6
Covering terminal board
• The recommended cross-section area
is six square millimetres (6 mm²).
• When you refit the mains terminal
cover, make sure that the lower tabs
are located inside the bottom edge of
the aperture, before you fix the two
screws into the top edge of the mains
terminal cover.
• Make sure that the cover is securely
fastened.
To open the cover of
terminal board obey the
procedure in opposite
sequence.
13.7
Terminal board
Do not remove blanking
plates.
Make sure that the links are fitted as
shown.
N
N
N
L
L
14.
ENERGY EFFICIENCY
14.1
Product information for hob according to EU 66/2014
Model identification
47102V-MN
Type of hob
Hob inside Freestanding Cooker
Number of cooking zones
4
Heating technology
Radiant Heater
www.aeg.com
26
Summary of Contents for 47102V-MN
Page 1: ...EN User Manual Cooker 47102V MN ...
Page 29: ...ENGLISH 29 ...
Page 30: ...www aeg com 30 ...
Page 31: ...ENGLISH 31 ...