AEG 5000 Series, User Manual

Problem

Possible cause

Solution

The gasket is deformed or
dirty.

Refer to "Closing the door"
section.

Food products are not wrap-
ped properly.

Wrap the food products bet-
ter.

Temperature is set incorrect-
ly.

Refer to "Control Panel"
chapter.

Appliance is fully loaded and
is set to the lowest tempera-
ture.

Set a higher temperature.
Refer to "Control Panel"
chapter.

Temperature set in the ap-
pliance is too low and the
ambient temperature is too
high.

Set a higher temperature.
Refer to "Control Panel"
chapter.

Water flows on the floor.

The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.

Attach the melting water
outlet to the evaporative
tray.

Temperature cannot be set.

The "Frostmatic function" is
switched on.

Switch off "Frostmatic func-
tion" manually, or wait until
the function deactivates au-
tomatically to set the tem-
perature. Refer to "Frost-
matic function" section.

The temperature in the ap-
pliance is too low/too high.

The temperature is not set
correctly.

Set a higher/lower tempera-
ture.

The door is not closed cor-
rectly.

Refer to "Closing the door"
section.

The food products' tempera-
ture is too high.

Let the food products tem-
perature decrease to room
temperature before storage.

Many food products are
stored at the same time.

Store less food products at
the same time.

The thickness of the frost is
greater than 4-5 mm.

Defrost the appliance.

The door has been opened
often.

Open the door only if neces-
sary.

The Frostmatic function is
switched on.

Refer to "Frostmatic func-
tion" section.

ENGLISH

15