Problem
Possible cause
Remedy
The water in the cavity em-
bossment does not boil.
The temperature is too low.
Set the temperature at least
to 110 °C.
Refer to “Hints and tips”
chapter.
The water comes out of the
cavity embossment.
There is too much water in
the cavity embossment.
Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with
a cloth or sponge. Add the
correct amount of water to
the cavity embossment. Re-
fer to the specific procedure.
The appliance is activated
and does not heat up. The
fan does not operate. The
display shows
"Demo"
.
The demo mode is activa-
ted.
1. Deactivate the oven.
2. Press and hold at the
same time
.
3. The first digit on the dis-
play and
Demo
indicator
start to blink.
4. Enter the code 2468 by
turning the knob for the
temperature right or left
to change the values
and press
to confirm.
5. The next digit starts to
blink.
6.
Demo
mode deactivates
when you confirm the
last digit and the code is
correct.
11.2
Service data
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the appliance
cavity. Do not remove the rating plate
from the appliance cavity.
We recommend that you write the data here:
Model (MOD.)
.........................................
Product number (PNC)
.........................................
Serial number (S.N.)
.........................................
www.aeg.com
32