8.2
Location
A
B
100 mm min
20 mm
The appliance should be installed well
away from sources of heat such as radia-
tors, boilers, direct sunlight etc. Ensure
that air can circulate freely around the
back of the cabinet. To ensure best per-
formance, if the appliance is positioned
below an overhanging wall unit, the min-
imum distance between the top of the
cabinet and the wall unit must be at least
100 mm . Ideally, however, the appliance
should not be positioned below over-
hanging wall units. Accurate levelling is
ensured by one or more adjustable feet
at the base of the cabinet.
WARNING!
It must be possible to disconnect
the appliance from the mains
power supply; the plug must
therefore be easily accessible af-
ter installation.
8.3
Electrical connection
Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.
8.4
Rear spacers
2
4
3
1
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1.
Release the screw.
2.
Engage the spacer below the screw.
3.
Turn the spacer to the right position.
4.
Tighten again the screws.
30 www.aeg.com
