AEG ABE6821VNF, User Manual

8.1 

Location

Refer to the assembly

instructions for the

installation.

To ensure best performance, install the

appliance well away from sources of heat

such as radiators, boilers, direct sunlight

etc. Make sure that air can circulate freely

around the back of the cabinet.

8.2 

Positioning

Install the appliance in a dry, well

ventilated indoors where the ambient

temperature corresponds to the climate

class indicated on the rating plate of the

appliance.

Climate
class

Ambient temperature

SN

+10°C to + 32°C

N

+16°C to + 32°C

ST

+16°C to + 38°C

T

+16°C to + 43°C

Some functional problems

might occur for some types

of models when operating

outside of that range. The

correct operation can only

be guaranteed within the

specified temperature

range. If you have any

doubts regarding where to

install the appliance, please

turn to the vendor, to our

customer service or to the

nearest Authorised Service

Centre.

8.3 

Electrical Connection

CAUTION!

Any electrical work required

to install this appliance

should be carried out by a

qualified electrician or

competent person.

WARNING!

This appliance must be

earthed.

The manufacturer declines

any liability should these

safety measures not be

observed.

The wires in the mains lead are coloured

in accordance with the following code:

A

B

C

D

E

•

A

 - green and yellow: Earth

•

C

 - brown: Live

•

D

 - blue: Neutral

As the colours of the wires in the mains

lead of this appliance may not

correspond with the coloured markings

identifying the terminals in your plug,

proceed as follows:

1.

Connect the wire coloured green and

yellow to the terminal marked either

with the letter “E“ or by the earth
symbol   or coloured green and

yellow.

2.

Connect the wire coloured blue to

the terminal either marked with the

letter “N“ or coloured black.

3.

Connect the wire coloured brown to

the terminal either marked with the

“L“ or coloured red.

4.

Check that no cut, or stray strands of

wire is present and the cord clamp

(

E

) is secure over the outer sheath.

Make sure the electricity supply

voltage is the same as that indicated

on the appliance rating plate.

5.

Switch on the appliance.

www.aeg.com

12