Problem
Possible cause
Solution
There is too much frost and
ice.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
Refer to "Closing the door".
Food products are not wrap-
ped properly.
Wrap the food products bet-
ter.
The compressor does not
start immediately after
pressing the FROSTMATIC,
or after changing the tem-
perature.
This is normal, no error has
occurred.
The compressor starts after a
period of time.
Water flows on the floor.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
Attach the melting water
outlet to the evaporative
tray.
Temperature cannot be set.
The FROSTMATIC function
is switched on.
Switch off FROSTMATIC
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FROSTMATIC function"
DEMO appears on the dis-
play.
The appliance is in demon-
stration mode.
Keep the OK button pressed
for approximately 10 sec-
onds until a long sound is
heard and display shuts off
for a short time.
The temperature in the ap-
pliance is too low/too high.
The temperature regulator is
not set correctly.
Set a higher/lower tempera-
ture.
The door is not closed cor-
rectly.
Refer to "Closing the door".
The food products' tempera-
ture is too high.
Let the food products tem-
perature decrease to room
temperature before storage.
Many food products are
stored at the same time.
Store less food products at
the same time.
The door has been opened
often.
Open the door only if neces-
sary.
The FROSTMATIC function
is switched on.
Refer to "FROSTMATIC
function".
There is no cold air circula-
tion in the appliance.
Make sure that there is cold
air circulation in the appli-
ance.
www.aeg.com
12
