28
www.aeg.com
11.4
Electrical Connection
This machine is designed to operate on
a 220-240 V, single-phase, 50 Hz
supply.
“An incorrect power supply may void
your warranty.”
Check that your domestic electrical
installation can take the maximum load
required, also taking into account any
other appliances in use.
CAUTION!
Connect the machine to an earthed
socket outlet.
CAUTION!
The manufacturer declines any
responsibility for damage or injury
through failure to comply with the
above safety precaution.
CAUTION!
Should the appliance power supply
cable need to be replaced, this shall
be carried out by our Service Centre.
When the appliance is installed, the
power supply cable must be easily
accessible.
11.5
Water Connection
Water tap must be installed within 110cm
of your dryer’s water inlet and the tap
must be 3/4 inch BSP thread for laundry
hose connection. Water pressure must be
between 200kpa to 800kpa.
Use the hose supplied with the dryer. DO
NOT USE OLD HOSES.
To connect the water inlet to dryer:
1. Turn off water supply to washer.
2. Remove inlet hose from water
supply.
3. Turn on water supply for a short
time to run some water into a
bucket or container to clear any
contaminants in the line.
4. Connect the Y-Connector to the
water tap.
water tap
Check
rubber seal,
replace if
worn.
Check
rubber seal
Summary of Contents for ADS854R5SB
Page 1: ...TUMBLE DRYER ADS854R5SB USER MANUAL ...
Page 30: ...30 www aeg com NOTE ...
Page 31: ...31 NOTE ...