AEG AGE725E4NW, User Manual

Problem

Possible cause

Solution

Food products placed in the

appliance were too warm.

Allow food products to cool

to room temperature before

storing.

The door is not closed cor‐

rectly.

Refer to "Closing the door"

section.

The FROSTMATIC function

is switched on.

Refer to "FROSTMATIC

function" section.

The compressor does not

start immediately after

pressing the "FROSTMAT‐

IC", or after changing the

temperature.

The compressor starts after

a period of time.

This is normal, no error has

occurred.

Door is misaligned or inter‐

feres with ventilation grill.

The appliance is not level‐

led.

Refer to installation instruc‐

tions.

Door does not open easily.

You attempted to re-open

the door immediately after

closing.

Wait at least 30 seconds be‐

tween closing and re-open‐

ing of the door.

Side panels of the appliance

are warm.

This is a normal state

caused by operation of the

heat exchanger.

The lamp does not work.

The lamp is in stand-by

mode.

Close and open the door.

The lamp is defective.

Contact the nearest Author‐

ized Service Centre.

There is too much frost and

ice.

The door is not closed cor‐

rectly.

Refer to "Closing the door"

section.

The gasket is deformed or

dirty.

Refer to "Closing the door"

section.

Food products are not wrap‐

ped properly.

Wrap the food products bet‐

ter.

Temperature is set incorrect‐

ly.

Refer to "Control Panel"

chapter.

Appliance is fully loaded and

is set to the lowest tempera‐

ture.

Set a higher temperature.

Refer to "Control Panel"

chapter.

Temperature set in the appli‐

ance is too low and the am‐

bient temperature is too

high.

Set a higher temperature.

Refer to "Control Panel"

chapter.

ENGLISH

15