AEG AGE725E4NW, User Manual

Problem

Possible cause

Solution

Water flows on the floor.

The melting water outlet is

not connected to the evapo‐

rative tray above the com‐

pressor.

Attach the melting water out‐

let to the evaporative tray.

Temperature cannot be set. The "FROSTMATIC func‐

tion" is switched on.

Switch off "FROSTMATIC

function" manually, or wait

until the function deactivates

automatically to set the tem‐

perature. Refer to "FROST‐

MATIC function" section.

The temperature in the appli‐

ance is too low/too high.

The temperature is not set

correctly.

Set a higher/lower tempera‐

ture.

The door is not closed cor‐

rectly.

Refer to "Closing the door"

section.

The food products' tempera‐

ture is too high.

Let the food products tem‐

perature decrease to room

temperature before storage.

Many food products are stor‐

ed at the same time.

Store less food products at

the same time.

The door has been opened

often.

Open the door only if neces‐

sary.

The FROSTMATIC function

is switched on.

Refer to "FROSTMATIC

function" section.

There is no cold air circula‐

tion in the appliance.

Make sure that there is cold

air circulation in the appli‐

ance. Refer to "Hints and

Tips" chapter.

Temperature setting LEDs

flash at the same time.

An error has occurred in

measuring the temperature.

Contact the nearest Author‐

ised Service Centre. The

cooling system will continue

to keep food products cold,

but temperature adjustment

will not be possible.

If the advice does not lead to

the desired result, call the

nearest Authorized Service

Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

8.3 Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer

to installation instructions.

www.aeg.com

16