AEG AGE725E4NW, User Manual

This appliance is not intended to be used

as a built-in appliance.
In case of different installation from

freestanding respecting space required

in use dimensions, the appliance will

function correctly but energy

consumption might increase slightly.
To ensure appliance's best functionality,

you should not install the appliance in the

nearby of the heat source (oven, stoves,

radiators, cookers or hobs) or in a place

with direct sunlight. Make sure that air

can circulate freely around the back of

the cabinet.
This appliance should be installed in a

dry, well ventilated indoor position.
To ensure best performance, if the

appliance is positioned below an

overhanging wall unit, the minimum

distance between the top of the cabinet

shall be maintained. Ideally, however,

the appliance should not be positioned

below overhanging wall units. One or

more adjustable feet at the base of the

cabinet ensure that the appliance stands

level.

CAUTION!

If you position the appliance

against the wall, use back

spacers provided or keep

the minimum distance

indicated in the installation

instructions.

CAUTION!

If you install the appliance

next to a wall, refer to the

installation instructions to

understand the minimum

distance between the wall

and the side of the appliance

where door hinges are to

provide enough space to

open the door when the

internal equipment is

removed (e.g. when

cleaning).

This appliance is intended to be used at

ambient temperature ranging from 10°C

to 43°C.

The correct operation of the

appliance can only be

guaranteed within the

specified temperature range.

If you have any doubts

regarding where to install the

appliance, please turn to the

vendor, to our customer

service or to the nearest

Authorised Service Centre.

It must be possible to

disconnect the appliance

from the mains power

supply. The plug must

therefore be easily

accessible after installation.

3.3 Electrical connection

• Before plugging in, ensure that the

voltage and frequency shown on the

rating plate correspond to your

domestic power supply.

• The appliance must be earthed. The

power supply cable plug is provided

with a contact for this purpose. If the

domestic power supply socket is not

earthed, connect the appliance to a

separate earth in compliance with

current regulations, consulting a

qualified electrician.

• The manufacturer declines all

responsibility if the above safety

precautions are not observed.

• This appliance complies with the

E.E.C. Directives.

3.4 Door reversibility

Please refer to the separate document

with instructions on installation and door

reversal.

CAUTION!

At every stage of reversing

the door protect the floor

from scratching with a

durable material.

www.aeg.com

8